Reset IkaScope to factory settings

If you want your IkaScope to “forget” all registered wifi networks or if you have some trouble configuring your wifi connection, you can always reset your device by pushing the reset button. This will reset IkaScope to factory settings.

  1. First unplug your device from any electrical connection
  2. Start your IkaScope by pressing ProbeClick™ tip
  3. Use a non conductive pin to push the reset button as shown on the image below
  4. The device will fully erase the wifi configuration (factory setting) and will restart in AP mode

reset button for IkaScope WS200 oscilloscope

Note: Factory reset will not roll back any firmware updates made to the device.